Metope sticks ceramic tile, can have two kinds of choice at present, one kind is to buy finished product adhesive to be pasted directly to the market, another kind is the spot to make up.
At present, there are three kinds of adhesive commonly used in the market:
The first is instant quick adhesive, which can be used directly. When used, a thin layer of glue is applied on the wall surface and the back of the ceramic tile. After drying for several minutes, when the glue surface is not sticky, it can be pressed on the wall. It is very convenient to use.
The 2nd kind is binder of JD-503 ceramic tile, the product is white powder, add water to adjust when using viscous glue fluid. This kind of product not only has a strong adsorption force, but also has a certain time to do the paste adjustment. The adjusted glue should be used up within 4 hours. General glue thickness between 3~5 mm.
The third is 903 multi-functional building glue, is also a direct use of the product, this product has high bond strength, 2 hours can be adjusted, scraping glue thickness of 2 mm, very convenient to use. The selection of finished adhesive paste, the cost is higher, suitable for the wall base surface bucket I is often flat, otherwise the cost of paste will increase.
The family decorates in paste wall face brick commonly uses the method that the site confuses 107 glue cement glue orange agent. With the volume ratio of cement 2107 glue 2 water =100210220, the bonding thickness is within 5 mm, the time can be adjusted for several hours, the wall surface requirements are low, it is the most economical and practical adhesive.